Wall Hay Rack cm212 $55.00 | Wall Model Hay Rack
• Top opening is 2 feet wide x 1 foot deep. Unit is 2 feet high.
• Open space between bars for safety.
• Four corner mounting for rigidity.
• All steel welded construction using 7/16" hot rolled steel. (color black)
| | |
|
Model brh04 $59.00 | Large Wall Hay Rack
Heavy-duty, powder-coated 1/2" welded rod construction racks.
Wall Rack
Size: 25" L x 36" W x 12" H
| | |
|
Corner Hay Rack cm213 $55.00 | Corner Model Hay Rack Model
Maximize stall Space with this heavy duty Hay Rack
• Rugged welded construction
• All steel welded construction
using 7/16" hot rolled steel.
• Big 30 inch opening at top,
tapered to 16 inches at bottom. (color black)
| | |
|
| |
High Strength - No Corrosion Lifetime Feeders
Rugged Cast Aluminum
Extremely heavy duty cast aluminum provides the toughest structure, yet is light in weight. You get both the advantages of plastic (corrosion prevention) and steel (high strength) with cast aluminum. With horses and other live stock, RUGGED CONSTRUCTION is a must. Both feeders have spherical shaped bottoms which causes the feed to flow to a single low point allowing easy clean up by the animal. If you have grown tired of constantly replacing the rubber and plastic feeders, here is the one-time solution!
|
Cast Aluminum Corner Feeder cm34 $115.00 | Corner Feeder
• Holds up to 3 gallons
• Four point mounting
• Each mounting surface is 16 in. long with a depth of 6 in.
• Weight approximately 11 lbs.
| | |
|
Feed Save Lid for Corner Feeder cm34L $22.00 | Feed Saver Lid for Corner Feeders
Stops the annoying and the wasteful habit some horses have of slinging their grain out of the feeder and onto the floor! The center opening is 5 3/4" wide. The steel bars are welded in place onto the heavy steel frame. Each Feed Saver Lid comes with 2 hold down brackets to attach to the feeder mounting hardware, but allows for easy cleaning. Designed to fit our cast aluminum corner feeders only.
| | |
|
Cast Aluminum Wall Feeder cm33 $115.00 | Flat Wall Feeder
• Holds up to 3 gallons
• Three point mounting for stability
• 20 in. wide at rear x 6 in. deep x 12 in. front to back.
• Weight approximately 13 lbs.
| | |
|
 Feed Save Lid for Wall Feeder cm33L $22.00 | Feed Saver Lid for Wall Feeders
Stops the annoying and the wasteful habit some horses have of slinging their grain out of the feeder and onto the floor! The center opening is 6" wide. The steel bars are welded in place onto the heavy steel frame. Each Feed Saver Lid comes with 2 hold down brackets to attach to the feeder mounting hardware, but allows for easy cleaning. Designed to fit our cast aluminum wall feeders only.
| | |
|
Single Mineral Block Feeder cm35 $35.00 | Mineral Block Holders
Both Mineral Holders have the same basic heavy duty design to accept either one, or two, standard blocks of salt or mineral. Two mounting holes are located to provide rigid mounting and protect against either upward or downward force that may occur. The double block holder dimensions are approximately 10 in. x 7 in. x 3 in. and the single holder 5 in. x 7 in. x 3 in.
Single Block Mineral Holder CM 35
• Weight approximately 3 lbs.
| | |
|
Double Mineral Block Feeder cm36 $35.00 | Double Block Mineral Holder CM 36
• Weight approximately 5 lbs.
| | |
|